Older News

  • Version 1.1.1-rc released

    28 October, 2015

    The is a release candidate for the upcoming 1.1.1. This release includes further ARM optimizations. The quality should again be unchanged. downloads page.

  • Version 1.1.1-beta released

    15 October, 2014

    The is a beta release for the upcoming 1.1.1. This release focuses on code optimizations, especially on x86, MIPS and ARM. The quality should be unchanged. downloads page.

  • Version 1.1 released

    5 December, 2013

    After more than two years of development, we have released Opus 1.1. This includes:

    • new analysis code and tuning that significantly improves encoding quality, especially for variable-bitrate (VBR),
    • automatic detection of speech or music to decide which encoding mode to use,
    • surround with good quality at 128 kbps for 5.1 and usable down to 48 kbps, and
    • speed improvements on all architectures, especially ARM, where decoding uses around 40% less CPU and encoding uses around 30% less CPU.
    These improvements are explained in more details in Monty's demo (updated from the 1.1 beta demo).
  • Version 1.1-rc3 released

    3 December, 2013

    This is the third and likely last release candidate for 1.1. It fixes several bugs in the fixed-point build. Floating point is unaffected. The code is available from the downloads page.

  • Version 1.1-rc2 released

    27 November, 2013

    This second release candidate fixes an alignment issue on ARMv5E and improves the Neon optimizations. Other platforms are unaffected. The code is available from the downloads page.

  • Version 1.1-rc released

    26 November, 2013

    We're getting closer to the final 1.1 with this new release that further improves surround encoding quality. It also includes better tuning of surround and stereo for lower bitrates. The complexity has been reduced on all CPUs, but especially ARM, which now has Neon assembly for the encoder. At last, there are a few bugfixes. The code is available from the downloads page.

  • Versions 1.1-beta and 1.0.3 released

    11 July, 2013

    Following up on the alpha, here's now the beta release for version 1.1. Monty wrote a nice demo page showing off all the improvements in 1.1. As for version 1.0.3 it includes a backport of the new 1.1 surround API (see the demo) as well as some minor bugfixes. The code is available from the downloads page.

  • Version 1.1-alpha released

    21 December, 2012

    This is an alpha release for the upcoming 1.1 version. Compared to 1.0.2, it includes quality improvements, optimizations, bug fixes, as well as an experimental speech/music detector for mode decisions. All the fixes and improvements from 1.0.2 are also in this release. Quality improvements include unconstrained VBR, a bitrate boost for tonal frames, and improvements to tf estimation, transient detection and dynamic allocation. The code is available from the downloads page.

  • Version 1.0.2 released

    6 December, 2012

    Opus 1.0.2 fixes an out-of-bounds read that could be triggered by a malicious Opus packet causing an integer wrap-around in the padding code. Considering that the packet would have to be at least 16 MB in size and that no out-of-bounds write is possible, the severity is very low. Other changes include fixes and improvements to the PLC and hybrid mode quality improvements. As usual, this release is fully compliant with the Opus specification. The code is available from the downloads page.

  • Opus Standardized as RFC6716, Versions 1.0.0 and 1.0.1 Are Available

    11 September, 2012

    It's official, Opus has now been standardized by the IETF as RFC 6716. Along with the RFC are the first stable releases. Version 1.0.0 includes exactly the same source code as the reference implementation in the RFC. Version 1.0.1 also includes minor fixes that were made after the RFC was "frozen". Both releases are available from the downloads page.

  • Third Release Candidate for Opus 1.0.1

    4 September, 2012

    This third release candidate for 1.0.1 has documenation and minor portability fixes as part of the final polish before release. Source code is available from the downloads page.

  • Second Release Candidate for Opus 1.0.1

    15 August, 2012

    This second release candidate for 1.0.1 includes documentation fixes and a Windows build system. Source code is available from the archived downloads page.

  • Release Candidates for Opus 1.0.0 and 1.0.1

    8 August, 2012

    Release candidates for the upcoming 1.0.0 and 1.0.1 releases are now available. Expect the final 1.0.0 release in the next few weeks along with the final Opus RFC. Version 1.0.1 will be released at the same time and includes minor fixes that did not make it to the RFC. Source code is available from the downloads page.

  • WebRTC Adopts Opus as MTI Codec

    27 July, 2012

    Participants to the IETF rtcweb working group have accepted (through typical IETF strong consensus) a proposal to select both Opus and G.711 as mandatory-to-implement (MTI) audio codecs. This means that all browsers that implement that standard will have to ship Opus support.

  • Opus Ships in Firefox 15 (beta)

    19 July, 2012

    The latest Firefox beta now ships with support for Opus.

  • Opus Approved by the IETF

    2 July, 2012

    The IETF has just approved Opus for publication as an RFC. This should happen in the next few weeks, along with release 1.0.